Here is information concerning the blades and cutting position for the HT series of rotary stripper. The measurements are in MM. Please be aware, the blade position the manufacturer uses are for a general overall best fit and rarely does the stripper fit the exact cut need, however in many case it is close enough to do the task. Our brand of connector's cutting detail can be found in the link at the bottom of our website pages and the link is called "Coax Cutting Chart"
The 3 blade models will perform three cuts, primarily for cutting the jacket, shield and dielectric each to a different length. A 2 blade model will perform two cuts and is normally used where the jacket and shield would be cut at the same length leaving the dielectric to be cut as the 2nd cut although some use it to cut the jacket and having the 2nd blade cut the shield and dielectric to the same length.
If you look at the chart below, from left to right, think of this as the jacket, shield and dielectric on the 3 blade cutters. Looking at the 2 blade cutters think of what you are seeing as the jacket/shield the same length and then the dielectric. The center RF wire is of course at the far right.
